Skip to content
مورد مصر MAWRED EGYPT
Marble polishing and burnishing machine

SKU FM-04

Marble polishing and burnishing machine

A marble polishing machine spins a polishing pad at high speed to bring back the shine on marble and glossy tiles after washing, without heavy chemical use. It suits hotel lobbies, office buildings and malls where the look of the floor matters to visitors.

Updated

SKU
FM-04
Category
Cleaning machines
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Factory cleaning supplies، Mall and shopping centre cleaning supplies، Cleaning supplies for residential compounds

Not suitable for: Not for scrubbing or removing heavy soil, nor for carpet, rough floors or concrete.

Specifications

OperationPad driver spinning at high speed, steered from the handle
Power sourceMains cable or battery, depending on the model
UseDry burnishing and restoring shine after washing
Suitable floorsMarble, polished granite, glossy tiles and waxed floors
ConsumablesLight-coloured polishing pads
Base size and speedBy model, confirmed in the quote
SKUFM-04

What this machine actually does

Daily foot traffic takes the shine off marble through fine scratches and grit rubbing across the surface. A polishing machine does not wash. It runs a soft pad at high speed over a clean floor, smoothing the surface so it reflects light again. That is why it always comes after washing, never before, and works best on a completely dry floor.

How it differs from a single disc

A single disc turns relatively slowly with more force, which suits scrubbing, grinding and wax stripping. A burnisher spins much faster under lighter pressure, and its only job is gloss. A single disc can polish with the right pad, but in large lobbies a dedicated burnisher gets a clearer result in less time.

Grinding or polishing?

Grinding is a deeper treatment that takes a thin layer off the marble to deal with scratches and stains. It uses coarser pads or discs and special compounds, and is usually done at long intervals. Polishing is the frequent upkeep that holds the result. In your quote request, describe the condition of your marble and say whether you need regular gloss maintenance or treatment for a floor that has lost its shine completely.

Operating tips

Remove dust and sand before polishing, because grit trapped under the pad scratches the surface. Keep the machine moving and never let it spin in one spot. Flip or change the pad once it loads up with dirt; a dirty pad gives a dull finish. In enclosed areas, work outside peak hours, since fine dust is thrown up while polishing.

What to write in your quote request

Give the approximate area of marble or glossy tile that needs polishing, its current condition, and whether it is washed daily by machine or by mop. Say whether lobbies have sockets nearby, or whether cable runs are awkward and a battery model would suit better. Mention the hours you can work: lobbies that never close need a plan that polishes in sections. If the building has several floor finishes, list them so we can suggest the right pads for each.

Alternatives

Frequently asked questions

Does the machine need polishing chemicals?
Many teams burnish dry on a clean floor, while some use a maintenance spray made for marble or wax finishes. Choose the product for your floor type and follow the label instructions.
Does it work on ordinary ceramic tiles?
Matt ceramic does not gain shine from burnishing, so there is little benefit. Glossy tiles and polished porcelain do benefit.
How often should marble be polished?
It depends on foot traffic, so busy lobbies may need polishing several times a week and quiet corridors less. Watch how the floor reflects light and use that as the team's guide.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.