Ride-on scrubber dryer
Seated operator, battery powered
Add to quote
SKU FM-01
A walk-behind scrubber dryer is pushed by the operator, scrubs the floor with a rotating brush and vacuums the dirty water through a rear rubber squeegee in one pass, leaving the floor almost dry. It suits corridors, hospitals, offices, shops and schools that wash hard floors daily and cannot leave them wet in front of people.
Updated
Suitable for: Hospital cleaning supplies، Factory cleaning supplies، Mall and shopping centre cleaning supplies، Cleaning supplies for residential compounds
Not suitable for: Not for carpet, uneven outdoor yards or very large open areas better served by a ride-on machine.
| Operation | Pushed and steered by the operator from the handle |
|---|---|
| Power source | Mains cable or rechargeable battery, depending on the model |
| Scrubbing system | Rotating brush or pad with cleaning solution feed |
| Drying system | Rear rubber squeegee that draws water into the recovery tank |
| Tanks | Separate clean solution and dirty water tanks |
| Suitable floors | Ceramic, porcelain, epoxy, vinyl and sealed concrete |
| Cleaning width and tank capacity | By model, confirmed in the quote |
| SKU | FM-01 |
Hand mopping moves dirty water from one spot to the next and leaves the floor wet for a while, which is exactly when people slip. A scrubber dryer scrubs with the brush and pulls the water straight into a separate tank, so the floor is fit to walk on again within a short time. That matters in hospitals, airports and shopping centres where corridors cannot be closed for cleaning.
A corded model suits defined areas close to sockets, and upkeep is simpler because there is no battery to replace as it ages. A battery model moves freely between departments and leaves no cable across the path of patients or visitors. It does need a fixed charging spot and a team that actually puts it on charge after every shift. If corridors are busy all day, battery is usually the better fit.
A wider machine covers more floor per pass, but it is heavier and harder to turn between furniture and doorways. Size it to the narrowest corridor it will work in, not only to the total area. Send us the area washed daily, corridor widths and lift door widths, and we will propose a size in the quote.
Use a low foam cleaner made for machines, because excess foam reaches the vacuum motor. Empty and rinse the recovery tank at the end of each shift. Clear hair and grit from the rubber squeegee, since any nick in the blade leaves water lines on the floor. Squeegee blades and brushes wear with use, so it makes sense to order spares with the machine.
To get the model right first time, give the approximate area washed per shift, the floor types in corridors, rooms and washrooms, and the narrowest corridor or door the machine must pass. Say whether sockets are close together and whether you have a charging and storage spot near a water point and drain. If the machine will run at night in wards or guest floors, tell us, as noise level becomes part of the choice. A team new to machines can ask for an operating and daily care briefing at handover.
Seated operator, battery powered
Add to quoteOne disc for a brush or pad
Add to quoteSend your list of items and quantities and we reply with a written quote.