Skip to content
مورد مصر MAWRED EGYPT
Ride-on scrubber dryer

SKU FM-02

Ride-on scrubber dryer

A ride-on scrubber dryer is driven by a seated operator and scrubs the floor and vacuums the dirty water in one pass over large areas without tiring the operator. It is built for factories, warehouses, malls, airports and large hospitals that wash open halls every day.

Updated

SKU
FM-02
Category
Cleaning machines
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Factory cleaning supplies، Mall and shopping centre cleaning supplies، Cleaning supplies for residential compounds

Not suitable for: Not suited to small offices, narrow corridors or buildings whose lifts and doors cannot take the machine.

Specifications

OperationDriven by a seated operator with steering wheel and pedal
Power sourceRechargeable batteries
Scrubbing systemRotating brushes or pads with cleaning solution feed
Drying systemRear rubber squeegee into the recovery tank
Suitable floorsEpoxy, sealed concrete, ceramic and porcelain in open areas
Cleaning width and tank capacityBy model, confirmed in the quote
SKUFM-02

When a ride-on machine pays its way

A ride-on is a bigger investment than a walk-behind scrubber, and only a large area washed on a regular basis justifies it. A practical test is how long your staff spend washing open halls every day. If the team spends most of a shift behind walk-behind machines in a production hall, warehouse or wide concourse, a ride-on gets the job done in much less time with one operator, and the strain injuries that come from constant pushing drop as well.

What you need before buying

The machine needs a storage room with a door wide enough to drive in, a suitable power point for charging, and a water point and drain nearby for filling the solution tank and emptying the recovery tank. If it will move between floors, check that the lift can carry its weight and fit it. Look at ramps and floor joints too, because a large machine needs a reasonably level floor.

The operator and training

The operator needs training in safe driving around pedestrians and forklifts, in setting solution flow and brush pressure, and in the charging and emptying routine at the end of the shift. Assign the machine to one named operator. Machines that everyone takes turns on get neglected faster.

Maintenance and consumables

Brushes, the rear squeegee and filters are consumables replaced on a cycle. Batteries need full charges and should never sit flat for long periods. Use low foam detergents made for machines. Tell us about the site and the main type of soil, whether oil, dust or food waste, and we will suggest the right brushes in the quote.

What to write in your quote request

Give the approximate area of halls washed daily, the floor type and its condition, and the main kind of dirt. State the width of the doors and aisles the machine has to pass, and whether it stays on one floor or travels by lift. Add the number of shifts it will run, since that affects battery choice and the charging setup. If the building also has narrow corridors, washrooms and small rooms, list them as well, so the same quote covers equipment for those spaces and no part of the site is left without the right machine.

Alternatives

Frequently asked questions

Does it work in warehouses with forklifts?
Yes, warehouses are one of its main uses, provided cleaning routes and times are coordinated with forklift traffic. Brushes suited to oil stains and tyre marks are advisable.
Is it suitable for hospital corridors?
It suits wide main corridors and lobbies in large hospitals. Narrow corridors and patient rooms are better served by a walk-behind scrubber.
Do I also need a walk-behind scrubber?
On most sites yes, because a ride-on cannot reach corners, narrow aisles and washrooms. A common setup is the ride-on for halls and a walk-behind for the rest.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.