Skip to content
مورد مصر MAWRED EGYPT
High-speed hand dryer

SKU HD-F01

High-speed hand dryer

A high-speed hand dryer is wall-mounted and used with the hands held under it. A narrow outlet sends out a fast, focused airstream that pushes water off the hands in less time than a conventional warm-air dryer. It suits washrooms in restaurants, schools, clubs and office buildings that get busy at set times and have no wall space for a large hands-in jet unit.

Updated

SKU
HD-F01
Category
Hand dryers
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Office cleaning supplies، Restaurant and cafe cleaning supplies، School and university cleaning supplies، Mall and shopping centre cleaning supplies، Cleaning supplies for clubs and gyms

Not suitable for: Not suited to washrooms next to patient rooms or meeting rooms, because it is audible, and it should not go above a floor that turns slippery when wet unless that is dealt with, since water falls beneath it.

Specifications

Drying methodHigh-velocity air from a narrow outlet
Hand positionUnder the dryer
ActivationAutomatic touch-free sensor
CasingStainless steel or reinforced plastic, depending on the model
HeatingHeating element, switchable on some models
Power, air speed and noise levelBy model, confirmed in the quote
SKUHD-F01

Drying by speed instead of heat

A conventional dryer warms the air so that water evaporates from the skin, which takes long enough that many people walk away with wet hands. A high-speed dryer works on a different principle. A fast-spinning motor forces air through a narrow outlet, producing a strong stream that scrapes water off the hands and sends it downward. Heat is there for comfort and is not the basis of the drying, which is why the unit uses less electricity per use despite its powerful motor.

Where it sits between a conventional and a jet dryer

A hands-in jet dryer is faster and collects the water in a tray, but it is bulky and somebody has to empty and clean that tray. A conventional dryer is quiet and simple but slow. The high-speed dryer falls in between: it is close in size to a conventional unit and mounts in the same place on the same wall, its speed approaches that of a jet unit, and it has no tray to service. It is the usual pick for raising the performance of an existing washroom without altering the fit-out.

Noise and falling water

Strong airflow has two costs. The first is noise, which is higher than a conventional dryer's and more noticeable in small tiled washrooms. The second is that water lands on the floor or on the wall below the unit. Both are managed by mounting the dryer away from the walking route, fitting a splash panel on the wall beneath it where the paint would suffer, and having the cleaner pass with a mop at short intervals during busy hours.

Mounting and electrical supply

Fix the dryer at a height that suits its users, and lower it in children's washrooms in schools. It needs a nearby supply with a safe, earthed connection made by a qualified electrician, never an extension lead. Leave enough distance from the basin so that people washing and people drying do not crowd each other, and keep it clear of any reflective surface under the sensor that could trigger it for no reason.

Routine cleaning

Wipe the casing and outlet daily with a cloth dampened with neutral cleaner, and never spray water straight onto the unit. The air intake, usually underneath or at the sides, gathers lint and dust, and cleaning it regularly keeps the airstream strong. If the model has a filter, replace or wash it as its instructions say.

What we need in order to settle on a model

State the number of washrooms and of dryers in each, the type of building and its peak times. Say whether you are replacing existing dryers or fitting out new washrooms, and whether the wiring is in place. Add the casing material you prefer, and whether the washroom is near areas that need quiet.

Alternatives

Frequently asked questions

Can it replace an old warm-air dryer in the same spot?
In most cases yes, because the size and fixing method are similar. An electrician should confirm that the existing connection suits the new unit's rating, and the screw positions may differ.
Is the air it blows hot?
It is warm on models with a heating element, and some let you switch the heating off in summer. Either way, the drying is done by air speed.
How many dryers does one washroom need?
That depends on the number of basins and of users at peak time. The practical rule is that people should not queue at the dryer, and we suggest a number once we know the washroom details.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.