Window squeegee
Metal channel with replaceable rubber
Add to quote
SKU GL-02
A window washer with an absorbent microfiber or plush sleeve on a T-bar, which carries the cleaning solution and washes the glass before the squeegee pulls it dry. It suits cleaning staff in companies, hotels, malls and cleaning contractors who clean windows and facades.
Updated
Suitable for: Hotel cleaning supplies، Office cleaning supplies، Mall and shopping centre cleaning supplies، Cleaning supplies for residential compounds
Not suitable for: Does not dry glass on its own because it leaves water behind, and will not remove stuck paint or stickers.
| Holder | T-bar holder |
|---|---|
| Sleeve | Microfiber or white plush depending on the type |
| Spare | Sleeve is removable, washable and replaceable |
| Fitting | Fits a telescopic pole for high glass |
| Use | Washing windows, facades and glass surfaces |
| Widths | By model, confirmed in the quote |
| SKU | GL-02 |
The washer is the first step in cleaning glass. It is dipped in a bucket of solution and run over the pane to wet it completely and loosen dust, marks and fingerprints. The squeegee then follows to draw off the water and dirt together. Without a good washer, the cleaner has to spray solution and wipe with cloths, which is far slower on facades and large windows.
A white plush sleeve holds a lot of solution, so it suits wide facades and glass covered in outdoor dust. A microfibre sleeve picks up fine soil and fingerprints well and suits interior glass, mirrors and areas cleaned on a regular cycle. Some sleeves combine both materials with a light abrasive strip for stubborn spots. Tell us what kind of dirt you mostly deal with and we will suggest a sleeve.
The washer should be the same width as the squeegee or slightly wider, so every strip the squeegee pulls has been washed. If the washer is narrower, the squeegee runs over glass that was not properly wetted and leaves streaks and spots. For this reason the two are usually ordered at the same width.
The T-bar lasts a long time; the sleeve wears with use and washing. Take it off after work and machine wash it without fabric softener, then let it dry before the next job. A spare sleeve per cleaner keeps work going while the other is in the wash. Replace a sleeve once its fibres mat or it stops holding solution.
Dip the washer in the solution and squeeze it lightly so it does not drip heavily, then run it over the glass from top to bottom, paying attention to corners and edges. Mix the solution as the label directs, because too much detergent leaves a tacky film the squeegee struggles to clear.
The washer always works with a squeegee, a bucket wide enough for it and a cloth for the edges. For high glass, the T-bar fits the telescopic pole just like the squeegee, so the cleaner can swap tools on one pole.
Give the width of the squeegees you use or plan to order, the glass type (interior or exterior facades), the number of cleaners and how many spare sleeves each one needs.
Metal channel with replaceable rubber
Add to quoteRectangular bucket that fits a full width washer
Add to quoteSend your list of items and quantities and we reply with a written quote.