Skip to content
مورد مصر MAWRED EGYPT
Automatic sensor soap dispenser

SKU SD-03

Automatic sensor soap dispenser

A wall-mounted automatic soap dispenser powered by batteries, releasing soap or sanitiser gel when a hand comes close, with no contact at all. It suits hospitals, clinics, busy office washrooms and malls that want to reduce touching shared surfaces.

Updated

SKU
SD-03
Category
Soap dispensers
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Hospital cleaning supplies، Hotel cleaning supplies، Office cleaning supplies، Factory cleaning supplies، Restaurant and cafe cleaning supplies، School and university cleaning supplies، Cleaning supplies for clubs and gyms

Not suitable for: Not suited to sites with nobody to keep up battery changes, or to very thick soap.

Specifications

OperationMotion sensor dispenses with no contact
Power sourceBatteries
Fluid typeLiquid soap or hand sanitiser gel depending on the model
MountingWall mounted, some models with a drip tray
MaterialDurable plastic
Capacities and coloursBy model, confirmed in the quote
SKUSD-03

Why sites choose a sensor dispenser

Everyone who uses a manual dispenser touches the button before washing, with hands that are not yet clean. In hospitals, clinics and hotel kitchens that is an obvious weak point in the hygiene routine. A sensor dispenser removes the step. The user brings a hand close, a set dose of soap or gel comes out, and the unit stops. A fixed dose also helps control consumption, since nobody presses the button several times in a row.

Soap or sanitiser gel

Some models are built for liquid soap at the basin; others are built for sanitiser gel at ward entrances and outside patient rooms, away from sinks. One model cannot always do both, because gel and soap have different consistencies. Say in your request where each dispenser will go and what it will be filled with.

Batteries and checks

The most important thing about this unit is that someone looks after it. Set up a simple battery check alongside the refill round and keep spare batteries in the cleaning store. When batteries run low, dispensing slows or stops, and users usually assume the unit is broken when all it needs is new batteries.

Where to install it

Fit the dispenser directly above or beside the basin, where strong sunlight does not fall on the sensor, since that can trigger it by mistake. If it goes at a ward entrance away from a basin, choose a model with a drip tray so the floor and wall stay clean.

Placement across a hospital

In hospitals, dispensers are not limited to washrooms. A gel unit usually goes at the entrance to each department and beside the door of each patient room, and a soap unit at every basin in consulting rooms and nurses' stations. When planning the order, walk the department with the infection control lead, mark the points together, then send us the count for each type.

What to give us in the request

Tell us the number of units, their locations, the fluid for each location and whether you need drip trays. If the same building has manual dispensers you plan to keep, list those too so the refill products for both can be planned together.

Alternatives

Frequently asked questions

How long do the batteries last in a sensor dispenser?
It depends on daily use and battery type. The best practice is to check batteries alongside the regular refill schedule and keep spare refills on hand.
Can it be filled with any soap?
The fluid must match the model, since thick soap can clog the pump and gel needs a model built for it. Tell us what you use and we suggest the right model.
Why does it sometimes dispense when nobody is near?
This is usually caused by strong direct light on the sensor or a shiny object in front of it. Moving the unit slightly or shading the light source fixes it in most cases.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.