Skip to content
مورد مصر MAWRED EGYPT
Floor squeegee

SKU MP-06

Floor squeegee

A floor squeegee with a double rubber blade that pushes water and solutions toward the drain after floor washing. It is used in commercial kitchens, public washrooms, factories, car parks and laundry rooms of hotels and hospitals.

Updated

SKU
MP-06
Category
Mops and floor squeegees
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Hotel cleaning supplies، Factory cleaning supplies، School and university cleaning supplies، Cleaning supplies for residential compounds، Cleaning supplies for clubs and gyms

Not suitable for: Not suited to areas without a floor drain or slope, or to parquet and carpet.

Specifications

BladeDouble rubber blade that seals against the floor
HeadMetal, nickel or plastic depending on the model, straight or curved
FittingFits a handle by thread or clip
OperationManual push of water toward the drain
Suitable floorsCeramic, concrete, epoxy and anti-slip floors
SizesBy model, confirmed in the quote
SKUMP-06

When a squeegee beats a mop

Kitchens, public washrooms and factory floors are often washed with plenty of water and detergent. Soaking all of that up with a mop means wringing it out again and again, which takes time. A floor squeegee pushes the water straight to the drain in a few strokes; a mop then picks up whatever is left. The floor ends up drier and less slippery, and the job is done sooner.

The double blade

A double rubber blade touches the floor along two lines, so water that slips past the first is held by the second. The rubber matters more than anything else on this tool. Cracked or worn rubber leaves streaks of water behind, so check the blade regularly and replace it, or the whole squeegee, once damage shows.

Straight or curved?

A straight squeegee suits flat floors and corridors. A curved one gathers water towards its middle and works well in open areas with a drain in the centre. Head material also varies: light plastic that resists cleaning chemicals, or metal and nickel for heavy work in factories and car parks.

Technique

Start at the point furthest from the drain and draw the water towards it in overlapping strokes. Hold the handle at a steady angle so the blade stays flat on the floor. Pressing too hard bends the rubber and makes it less effective.

Care and storage

Rinse the blade after use. Hang the squeegee or store it so its weight does not rest on the rubber, which deforms the blade over time. Keep it away from direct heat.

Squeegees in commercial kitchens

Kitchen floors take grease, food scraps and water all day long. The usual sequence is to sweep up solid scraps first, apply a kitchen degreaser according to the label, scrub with a stiff deck brush, and then draw the water to the drain with the squeegee. Keep a separate squeegee for the kitchen, in a different colour from the washroom one, and never swap them between areas. At the end of the shift wash the grease off the blade thoroughly, because fat left on the rubber breaks it down.

Consumables and accessories

Alternatives

Frequently asked questions

What squeegee width should I choose?
A wide squeegee clears open areas faster but is harder to use in washrooms and narrow corridors. Many sites keep two widths, and we confirm available widths in the quote.
Will the squeegee fit our existing handle?
It fits if the handle uses the same fitting, thread or clip. Send us a photo of the handle tip so we can check before ordering.
Does a squeegee work on rough factory floors?
Yes, and metal-head models suit them better because they handle heavy use. The rubber wears faster on rough floors, so check it more often.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.