Skip to content
مورد مصر MAWRED EGYPT
Dust mop with frame

SKU MP-04

Dust mop with frame

A dust mop with a wide frame and a cotton or acrylic fringe that sweeps dry dust, grit and hair without water. It is used in large halls and corridors of hotels, hospitals, malls and factories before wet mopping or for daily dry passes.

Updated

SKU
MP-04
Category
Mops and floor squeegees
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Hotel cleaning supplies، Factory cleaning supplies، School and university cleaning supplies، Cleaning supplies for residential compounds، Cleaning supplies for clubs and gyms

Not suitable for: Not meant for wet mopping or sticky spots, or for small rooms crowded with furniture.

Specifications

FringeCotton or acrylic, depending on the model
FrameMetal or plastic, some models fold
OperationDry push sweeping, no water
Suitable floorsMarble, ceramic, vinyl and polished concrete
RefillsReplacement fringes ordered separately
WidthsBy model, confirmed in the quote
SKUMP-04

Where a dust mop fits in the cleaning routine

Most of the dirt in corridors and halls is dry dust and sand carried in on shoes. Mop that straight away with water and the sand turns to mud, the bucket goes grey within minutes, and the grit under the mop head acts like sandpaper on polished marble. A dust mop picks the loose soil up first, so the wet pass that follows is quicker and leaves a cleaner floor.

Choosing a width

A wide frame covers a lot of floor with each push, which makes it the natural choice for lobbies, function rooms and long corridors. It is harder to steer around columns and furniture, though. A narrower frame turns more easily in medium corridors, and many buildings keep one of each: a wide unit for open areas and a narrow one for passages.

Cotton or acrylic?

Cotton fringes absorb well and suit general use. Acrylic attracts fine dust and dries faster after laundering. Either type can be lightly misted with a dust-control treatment, following the label, to improve pick-up.

Using it properly

Push the mop in a straight line and keep it on the floor; lifting it releases the dust it has collected. At the end of each run, gather the dirt into a pile and lift it with a dustpan. When the shift ends, shake the fringe out of doors or wash it, depending on how dirty it is.

Care

Wash the fringe and let it dry completely before it goes back on the frame. Check the frame joint and the handle screws from time to time, since heavy daily use loosens them.

Dust-control spray

Some facilities treat the fringe with a dust-control spray, applied well before use so the fibres absorb it. It helps the mop hold fine dust and stops it drifting back into the air. Use only a small amount and follow the label, because too much leaves a slippery film. Avoid it on floors that will be washed straight afterwards with a cleaner that does not suit the treatment. If your team has not used one before, try it in a single short corridor and check the floor for slip before treating the whole building.

Consumables and accessories

Alternatives

Frequently asked questions

Can a dust mop replace a broom?
On large smooth halls and corridors yes, it is faster and does not raise dust the way a broom does. Outdoors and on rough floors a broom or yard brush is better.
Can the fringe be washed?
Yes, the fringe comes off the frame, is washed and dried fully before refitting. A spare fringe keeps work going while one is in the wash.
Is it suitable for carpet?
No, a dust mop is made for hard, smooth floors. Carpet needs a vacuum cleaner.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.