Skip to content
مورد مصر MAWRED EGYPT
Disposable beard cover

SKU GM-10

Disposable beard cover

A single-use beard cover in non-woven fabric, held by an elastic edge around the ears or behind the head, covering the chin and cheeks. It suits bearded staff in kitchens, food factories, bakeries and sterile rooms, and is worn with a hair cap.

Updated

SKU
GM-10
Category
Gloves and protective disposables
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Hospital cleaning supplies، Factory cleaning supplies، Restaurant and cafe cleaning supplies

Not suitable for: It is not a face mask, does not protect against dust or droplets when breathing, and is not suited to outdoor work.

Specifications

MaterialLight non-woven fabric
FasteningElastic around the ears or behind the head depending on the model
CoverageChin, cheeks and lower face
UseSingle use
PackPack depending on the model
ColoursBy model, confirmed in the quote
SKUGM-10

Why bearded staff need a separate cover

A hair cap gathers the hair on the head but leaves the beard exposed. Beard hair falls during talking and moving just as head hair does, and ends up in the product or on the plate. Food factories and central kitchens therefore ask bearded staff to wear a beard cover together with the hair cap for as long as they are in the preparation area.

Beard cover and face mask

A beard cover only stops hair falling. It does nothing to protect breathing. Where a mask is required, the worker wears the mask with the beard cover over or under it depending on how each is designed, so no hair shows around the mask edges. In some areas a mask that fully covers the chin is enough for a short beard; site instructions decide.

Wearing it properly

The cover should take in the chin, the cheeks and the area under the jaw. It is held by the elastic around the ears or behind the head, and the hair cap then goes on over the ears so there is no gap between the two. Put it on before washing hands and gloving, because adjusting it afterwards means touching the face with clean hands.

For visitors and technicians

A bearded visitor or maintenance technician needs the same cover when entering the production area. Keep a box of beard covers next to the hair caps and shoe covers at the entrance so the whole set is in one spot.

When to change it

Replace it at the start of every shift, after a break or a meal, and whenever it gets dirty or torn. Do not leave it hanging round the neck to pull back up later.

Storage

Keep packs closed in a dry, clean, dust-free place, and hand them out to entrances in quantities that cover the shift.

The supervisor's role

Beard cover compliance slips when it is left to each worker alone. It helps if the shift supervisor checks the full set at the start of work, and if boxes are always stocked at the entrance, so an empty box is never the reason someone walks in without one.

What to write in your quote request

Give the number of staff per shift who need a beard cover, expected visitor numbers and the fixing style you prefer.

Alternatives

Frequently asked questions

Does a beard cover replace a face mask?
No, it only stops hair from falling and does not protect against dust or droplets. Where a mask is required, both are worn together.
Does it fit a long beard?
The elastic edge and light fabric cover beards of different lengths. For a very long beard, check when putting it on that it reaches fully under the jaw.
Is the beard cover worn with a hair cap?
Yes, put on the beard cover first and then the hair cap over the ears so no gap is left between them. This order covers facial and head hair together.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.