Skip to content
مورد مصر MAWRED EGYPT
Manual push sweeper

SKU FM-08

Manual push sweeper

A manual push sweeper runs without mains or battery power, its brushes turning with the wheels to collect dust, leaves and dry debris into an internal hopper. It suits car parks, outdoor walkways and internal paths in factories, schools and residential compounds that want faster sweeping than a broom with no running costs.

Updated

SKU
FM-08
Category
Cleaning machines
Request a quote

We reply with a written quote after reviewing your request.

Suitable for: Factory cleaning supplies، Mall and shopping centre cleaning supplies، Cleaning supplies for residential compounds

Not suitable for: Not for wet debris or mud, very fine dust indoors, or very large areas better served by a ride-on sweeper.

Specifications

OperationPushed by hand, brushes driven by the wheels
Power sourceNo mains or battery needed
Sweeping systemMain brush with one or two side brushes, depending on the model
Debris collectionRemovable hopper emptied by hand
Suitable surfacesAsphalt, interlock paving, concrete and outdoor tiles
Sweeping width and hopper capacityBy model, confirmed in the quote
SKUFM-08

A practical step up from the broom outdoors

Sweeping a car park or a long outdoor walkway with a broom eats up a worker's time, raises dust and leaves piles of debris that still have to be picked up. A manual push sweeper sweeps and collects in one movement. The worker pushes it at normal walking pace and the debris ends up straight in the hopper. It has no motor, so there is no charging, no socket and no electrical servicing, and it can go anywhere.

One side brush or two?

The side brush pulls debris out of corners and kerb edges into the main brush. A single side brush is enough when the worker runs along a wall or kerb on one side. Two side brushes cover both sides in one pass and suit open walkways. The layout of the site should decide this, not the brush count on its own.

What it collects well

Dust, sand, leaves, cigarette ends and small light litter. Large items such as cardboard and bottles are better picked up by hand before sweeping. Wet debris and mud stick to the brushes and clog the hopper, so sweep once the ground is dry.

Simple maintenance

Empty the hopper before it is completely full, because an overfull hopper drops debris back on the ground. Clear string and wire wrapped around the brushes regularly, and check the brush height setting for the surface: set too high it leaves dust, set too low it wears fast. When the bristles have worn short, replace them to bring the sweeper back to full performance.

What to write in your quote request

Give the approximate area swept daily and the surface: asphalt, interlock paving, concrete or outdoor tiles. Describe the main debris, dust and sand, tree leaves, or light litter dropped by passers-by. Say whether the worker follows a kerb or wall or sweeps open yards on both sides, since that sets the number of side brushes. If you cover several zones or shifts, tell us how many workers there are and we will suggest how many sweepers you need.

Alternatives

Frequently asked questions

Can it be used indoors?
It suits warehouses, enclosed car parks and wide corridors with hard floors. In offices and fine-dust areas a vacuum is better because it captures dust instead of raising it.
Does it need a trained operator?
No special training is needed, as it is used much like pushing a cart. The operator only needs to know how to empty the hopper and adjust the brush.
When should I choose a ride-on sweeper instead?
When the area is so large that push sweeping takes most of the shift, or when debris is heavy and dense, as in factories and logistics yards.
Request a quote

Need a quote for your facility?

Send your list of items and quantities and we reply with a written quote.